This article concentrates on the enhanced Routing Information Protocol, also known as RIP version 2. I will show you the necessary configuration steps for RIPv2 so that you will be able to configure RIP on your own. Windows 7 Start Orb Changer V6 Engine on this page. Last time we covered, which included information on RIP operation, drawbacks, configuration, and much more. Today, we shift focus to RIPv2 and to illustrate the configuration steps I will use the same example I used in the first article, just for simplicity.

I'll also give you a brief overview of the most important parts of both versions of RIP, which should be very useful for all of you out there studying for the and exams. Routing Information Protocol Version 2 Both versions of RIP, RIPv1 and RIPv2, are Distance Vector Routing Protocols that use router hop counts as their metrics. Test Tools For Companies. They support a maximum hop count value of 15. Any router farther than 15 hops away is considered to be unreachable. The main enhancement of RIPv2 over its ancestor is the fact that it first sends the subnet mask with the updates; hence it is considered to be a classless routing protocol in the sense that it is able to distinguish among different subnets - which is something that is not found in RIPv1. Mx Simulator Race Factory Compound Sentence on this page. The following table presents in more details the main characteristics of RIPv2: Configuring RIPv2 As I mentioned before, I'll be using the same network diagram that I used in. Configuring RIP routing protocol consists of three basic steps: • Enabling RIP routing protocol on the router • Specifying the RIP version to run • Configuring the network addresses to be included in routing updates or specifying the interfaces to participate in routing updates Using the Cisco IOS, the command to enable RIP routing protocol is router rip.